Excessive foam in your washing machine: what to do and how to prevent it

If there is excessive foam, don't add detergent or foam-control products. Check whether the machine is running a programmed routine; if water is leaking out or there is an electrical hazard, make stopping it safely your priority.

Foam contained and cycle still running

Check the full message on the display. Some machines extend rinses or limit the spin cycle to manage foam. Whirlpool documents this behaviour in its front-loaders; don't apply the warnings or instructions in its manuals to another machine.

Let the recovery routine finish if the manual says to. If it asks you to take action, follow the steps given. Don't force the door open, open the filter during the cycle or add vinegar, oil or an improvised defoamer.

Overflow or water outside the machine

If you can stop the machine using a dry control without exposing yourself to water, do so. Don't touch wet plugs or connections. If you can't safely isolate the machine, keep your distance and get help. If water is coming out of the dispenser, check water coming out of the dispenser drawer, not just the detergent dose.

Work out the dose

  • Identify the product and its concentration, including whether it is HE or low-sudsing.
  • Include any additives or pre-treatment applied to the clothes.
  • Check whether automatic dosing was active as well as a manual dose.
  • Compare the amount used with the load size and the instructions on the packaging.

When the cycle is finished, check whether the clothes need the rinse recommended by the manufacturer. To prevent it happening again, adjust the dosage you've identified as the cause, without arbitrarily reducing it so much that the load isn't washed properly.

Before your next load of washing, work out where the excessive or incompatible dose came from so the incident doesn't happen again.

View all articles in Laundry detergents, dosing and additives