ASKO Error E3: filling problems

E3 on the ASKO WM76S indicates a filling problem. Check the water supply, inlet and drain hose position as described in the W3096RW manual before trying again.

From the tap to the water level

The manufacturer's documentation covers the tap, inlet mesh, hose and drain height. First check that the water supply is on and that a tap hasn't been turned off. Check the hose for any kinks or deformation.

If water enters but doesn't stay in the machine, note whether it's draining at the same time. Check the height and connection against the installation section: a setup that causes siphoning won't be fixed by restarting the control panel.

Accessible mesh and recovery

If the manual allows you to clean the inlet, turn off the water, prepare the machine and disconnect only the specified connection. Refit the mesh and seal, then check for leaks. The inlet filter guide explains how to prepare.

The WM76S manual says to continue by confirming on the control panel after checking the conditions. If E3 appears again, contact service and provide the model and your observations about the filling. Permitted water pressures are specified in the manual; don't apply those limits to other ASKO generations.

Distinguish restoring the water supply from clearing the message: only the former fixes a water outage.

View all articles in ASKO washing machine error codes and warnings