E3 on the ASKO WM76S indicates a filling problem. Check the water supply, inlet and drain hose positioning as per the W3096RW manual before trying again.
From the tap to the water level
The manufacturer's documentation covers the tap, inlet mesh, hose and drain height. First check whether water is being supplied and whether a tap has been left closed. Inspect the hose for any signs of crushing or deformation.
If water enters but does not stay in the machine, note whether it is draining at the same time. Compare the height and connection with the installation section: a setup that causes siphoning cannot be fixed by restarting the control panel.
Accessible mesh and recovery
If the manual permits cleaning the inlet, turn off the water, prepare the appliance and disconnect only the specified connection. Refit the mesh and seal, then check for leaks. The guide to inlet filters provides further preparation guidance.
The WM76S manual says to continue by confirming on the control panel after checking the conditions. If E3 appears again, request service and provide the model and your observations of the filling process. Permitted pressures are specified in the manual; do not apply those limits to other ASKO generations.
Distinguish restoring the water supply from clearing the message: only the former fixes a water outage.
View all articles in ASKO washing machine error codes and warnings
