Choose a spin speed that the garment and programme can handle. A higher speed may remove more water, but tolerance to creasing and distortion depends on the garment’s construction; there is no spin-speed chart that applies to every fibre.
Understand the options before changing the spin speed
| Option | When to use it |
|---|---|
| Spin only | Remove water from a load that has already been washed or rinsed, if your model offers this option. |
| No spin | Avoid the spin cycle; check whether the programme drains the water before it ends. |
| Rinse hold | The load may remain in water until you start the end sequence specified in the manual. |
Do not mistake a selected rinse hold for a drainage fault. Before removing the laundry, complete the permitted sequence and wait for the door to unlock normally.
Choose the spin intensity for the actual load
Check the care label and cycle restrictions. For knitwear, padded items or delicate finishes, the entire construction matters, not just the fibre. If you notice excessive creasing, also check how much you have loaded and how long the laundry stays in the machine after the cycle ends.
To run a separate spin cycle, check the load distribution and select a speed within the permitted limit. The maximum figure on the control panel does not guarantee that the machine will reach it: load distribution and cycle conditions may limit the speed. Do not repeat attempts with an item that is not suitable, or add makeshift weights.
If the laundry remains soaking wet despite the correct settings, or the drum does not turn, continue with the spin-cycle troubleshooting guide.
View all articles in Washing machine programmes, settings and controls
