Which spin speed to choose and how to run a spin-only cycle

Choose a spin speed that the garment and cycle can handle. A higher speed may remove more water, but tolerance for wrinkles and distortion depends on the garment’s construction; there is no spin-speed chart that applies to every fibre.

Understand the options before changing the spin speed

OptionWhen to use it
Spin onlyRemove water from a load that has already been washed or rinsed, if your model offers this cycle.
No spinSkip the spin cycle; check whether the program drains the water when it ends.
Rinse holdThe load may remain in water until you follow the end-of-cycle steps provided in the manual.

Don’t confuse a selected rinse hold with a drainage problem. Before removing the clothes, complete the approved sequence and wait for the door to unlock normally.

Choose a spin speed for the actual load

Check the care label and cycle restrictions. For knitwear, padded items or sensitive finishes, the overall construction matters, not just the fibre. If you notice excessive wrinkling, also check how much you’ve loaded and how long the clothes sit after the cycle ends.

To run a separate spin cycle, check the load distribution and select a speed within the permitted limit. The maximum number shown on the control panel doesn’t guarantee the appliance will reach it: load distribution and cycle conditions may limit the speed. Don’t repeat attempts with an item that isn’t approved for spinning, and don’t add improvised weights.

If the clothes remain soaking wet despite the correct settings, or the drum doesn’t spin, continue with spin troubleshooting.

View all articles in Washer cycles, settings and controls