Auto-dosing dispenses product from a reservoir or cartridge. The amount depends on the available settings and sensors; automatic dosing does not mean that all the dirt is measured directly.
From stored product to the drum
The system stores detergent in a refillable reservoir or uses a designated cartridge. A pump or dosing mechanism adds an amount as the detergent travels towards the wash. The automatic system described by LG SIGNATURE is an example of storage for several loads; other product ranges use different circuits and settings.
What information can it use?
- Base dose: the starting amount set for the product or reference load.
- Concentration: relates the volume dispensed to the effective amount of product.
- Water hardness: may need to be adjusted manually or may be part of the documented setup.
- Load and sensors: can help adjust the amount if the programme and appliance include this function.
A machine may estimate the weight without measuring turbidity, or dispense a base dose without recognising the fabric. Check what each sensor estimates before attributing capabilities of the control system to the reservoir.
Compatibility and manual alternatives
The product must be suitable for the reservoir, its permitted viscosity and the manufacturer's instructions. Do not mix different liquids or reuse a sealed cartridge without instructions. Changing the concentration without adjusting the reference amount can alter the dose, even when the mechanism works correctly.
Some cycles allow you to disable dosing or use a manual compartment; others have restrictions. The initial setup helps you find the available settings. Cleaning or a persistent failure to dispense requires following the specific procedures.
Check what determines the dose in your model before deciding whether the result is due to the setting, the product or the dispensing mechanism.
View all articles in Washing technologies: motors, sensors and automation
