Automatic dosing dispenses product from a reservoir or cartridge. The amount depends on the available settings and sensors; automatic dosing does not mean that all the dirt is measured directly.
From stored product to the drum
The system stores detergent in a refillable reservoir or uses a purpose-designed cartridge. A pump or dosing mechanism feeds an amount into the route to the wash. The automatic system described by LG SIGNATURE illustrates storage for several loads; other ranges use different circuits and settings.
What information can it use?
- Base dose: the starting point set for the product or reference load.
- Concentration: relates the volume dispensed to the effective amount of product.
- Water hardness: may require manual adjustment or form part of the documented settings.
- Load and sensors: can be used to adjust the amount if the programme and appliance include this function.
A machine may estimate weight without measuring turbidity, or dispense a base dose without recognising the fabric. Check what each sensor estimates before attributing capabilities of the controls to the reservoir.
Compatibility and manual alternatives
The product must be suitable for the reservoir, its permitted viscosity and the manufacturer's requirements. Do not mix different liquids or reuse a sealed cartridge without instructions. Changing the concentration without adjusting the reference setting may alter the dose, even if the mechanism is working correctly.
Some cycles allow you to switch off dosing or use a manual compartment; others impose restrictions. The initial setup helps you find the available settings. Cleaning or a persistent failure to dispense requires its own specific procedures.
Find out what determines the dose on your model before deciding whether the result is due to the setting, the product or the dispensing mechanism.
View all articles in Washing technologies: motors, sensors and automation
