On the documented Siemens models, E23 indicates a leak or water in the base. Shut off the water supply and avoid running any more cycles while you check the source.
Document the leak from the outside
The manufacturer’s documentation says to turn off the tap if a leak is suspected. Access the area from a dry spot; if water is around outlets or electrical connections, get help to isolate the appliance without coming into contact with the water.
Check whether the moisture starts at a hose, the drawer, the seal or underneath the housing. The cycle stage also matters: note whether it appears while filling, during washing or while draining. Don’t remove panels to locate water in the base tray.
Why drying it isn’t enough
The floor may be dry while the source of the leak remains active or water is still inside the base. Don’t tilt the washer to reset the protection. The guide to locating leaks from the outside can help you document the visible path of the water, but it can’t confirm an internal repair.
If the source isn’t accessible or the warning persists, request service and provide the E-Nr and photos. Don’t treat E23 as a universal instruction to replace a hose or sensor.
Containing the water protects the surrounding area; whether it’s safe to run another wash depends on resolving the cause.
View all articles in Siemens washing machine error codes and warnings
