The Bosch guide for E18 recommends checking the filter, accessible pump and drain hose. If water is trapped, prepare to drain it before removing any cap.
External checks
The drainage procedure in the manufacturer's documentation starts with draining the water. Check whether the hose was kinked when the washing machine was installed or whether the household siphon is blocked. Compare the installation with the E-Nr manual.
Open the filter with the water cool and under control
- Switch off and safely unplug the appliance. Wait for the wash water to cool.
- Keep a container ready and use the emergency hose or the draining method specified in the manual.
- Do not remove the cap completely while water is flowing; stop the flow to empty the container.
- Once empty, clean any accessible debris, the thread and the seating surface; then close it properly.
The guide to cleaning the drain filter provides further preparation advice. If the cap does not turn normally, do not force it with a tool.
If the filter and accessible outlet are clear but E18 persists, request service. Do not assume the pump has failed without a diagnosis, and do not run repeated cycles with water trapped inside.
Check that the filter is watertight before considering the cleaning complete.
View all articles in Bosch washing machine error codes and alerts
