Bosch E18 Error: Clogged Filter or Drain

The Bosch E18 guide recommends checking the filter, accessible pump and drain hose. If water is trapped, prepare to drain it before removing any cap.

External checks

The drainage procedure in the manufacturer’s documentation starts with checking the drainage path. Check whether the hose was kinked when the washer was installed or whether the household drain trap is clogged. Compare the installation with the E-Nr. manual.

Open the filter with the water cool and under control

  1. Turn off and safely unplug the appliance. Wait for the wash water to cool.
  2. Prepare a container and use the emergency drain hose or the draining method specified in the manual.
  3. Do not remove the cap completely while water is flowing; pause the flow to empty the container.
  4. Once empty, clean any accessible debris, the threads and the seat; then close it securely.

The drain filter cleaning guide provides more information on preparation. If the cap does not turn normally, do not force it with a tool.

If the filter and accessible outlet are clear but E18 persists, request service. Do not assume the pump has failed without a diagnosis, and do not run repeated cycles while water is trapped.

Check that the filter is watertight before considering the cleaning complete.

View all articles in Bosch washer error codes and warnings