Sharing a waste with a sink or dishwasher: connection requirements

Sharing a pipe is only viable if the connection and drainage system are set up for the intended appliances. An adapter with two outlets does not guarantee sufficient capacity, venting or protection against backflow.

What the installer needs to check

The installer needs to assess the flow rate when the appliances discharge at the same time, the pipe run to the drain, the trap’s function and the required venting. They should also consider water temperature, approved fittings and access for cleaning or servicing.

A system that works with one appliance may overflow when another drains at the same time. The point closest to the pool of water is not necessarily where the restriction is.

Purpose-designed fittings and prepared connections

The inlets must be designed for the hose and its method of attachment. Some fittings are supplied with sealed inlets; only remove the factory seal for the inlet being used, and follow the specified procedure. Do not drill unknown parts to create a branch.

The hose needs to be secured and routed in a way that is compatible with the appliance’s drain installation. Do not treat pipe diameters or gradients from another installation as a universal formula.

What to check during a simultaneous discharge test

The installer should check that water drains without overflowing, does not flow back into another appliance, and that the joints are accessible. Leaks and subsequent odours need to be investigated; do not conceal them by sealing vents or adding a non-return valve without checking the system.

If water appears in the washing machine when you use the sink, see water backing up after draining. The timing provides useful information, but does not confirm which fitting is incorrectly installed.

Check the system under simultaneous demand; one appliance draining successfully does not prove there is enough capacity for shared use.

View all articles in Installing a washing machine: requirements and checks