Washing machine belt and pulleys: check for wear and replace

A broken belt can interrupt movement, but if it keeps coming off, the pulleys, mounting and shaft need to be checked. Fitting another belt will not correct misalignment.

Confirm that the drive uses a belt

Not all drives use one. The model’s parts diagram shows its route and avoids searching for a belt in a direct-drive motor. If you only know the symptom, start with drum not spinning.

What to inspect

  • The belt for breaks, wear or contamination.
  • The condition of the pulley grooves and surfaces.
  • The fixings and alignment of the belt path.
  • Shaft play or drum movement that could make the belt come off.

Internal inspection must be carried out with the power isolated and access carried out as documented. Do not observe an exposed drive while it is running. The belt and pulley can trap fingers, even during manual fitting.

Choosing and checking the replacement

Select the compatible part number, not an approximate length. The profile, elasticity and construction must match the system. Do not estimate tension or torque by touch.

Do not lubricate the belt or stretch it to make it fit. After the repair, refit the guards and check the drive using the manufacturer’s method. If there was a burning rubber smell, investigate the cause before testing it again.

If the belt keeps coming off, check what guides its path; do not treat it as a simple fitting problem.

View all articles in Washing machine component diagnosis and repair