A broken belt can interrupt movement, but if it keeps coming off, the pulleys, fastenings and shaft need to be investigated. Fitting another belt won’t fix misalignment.
Confirm that it uses a belt drive
Not all drive systems use one. The model’s parts diagram shows its path and avoids searching for a belt in a direct-drive motor. If you only know the symptom, start with drum not spinning.
What to inspect
- Check the belt for breakage, wear or contamination.
- Check the condition of the pulley grooves and surfaces.
- Check the fastenings and alignment of the belt path.
- Check for shaft play or drum looseness that could cause the belt to come off.
Inspect the inside with the power isolated and access carried out as documented. Never observe an exposed drive system while it is running. The belt and pulley can trap fingers, even during manual assembly.
Choosing and checking a replacement
Select the compatible part number, not one with an approximate length. The profile, elasticity and construction must match the system. Tension and torque cannot be judged by feel.
Don’t lubricate the belt or stretch it to make it fit. After the repair, restore the guards and check the drive system using the manufacturer’s method. If there was a burnt rubber smell, investigate the cause before testing it again.
If the belt keeps coming off, check what guides its path; don’t treat it as a simple fitting problem.
View all articles in Washing machine component diagnosis and repair
