E33 warning on Siemens: excessive foam

E33 is documented by Siemens as a warning about excessive foam. Check the dose and the product before interpreting the interruption as an internal fault.

The same measure does not suit every load

The manufacturer’s documentation recommends reducing the detergent dose when the water is soft or the laundry is only lightly soiled. Check the concentration, the actual load and any pre-treatment products. If you use automatic dosing, check its settings and avoid adding a manual dose at the same time unless the programme requires it.

Foam can extend rinse cycles or affect the spin result. Check whether the machine is following a planned correction routine, and let it finish if there is no water leak.

After adjusting the product and amount

Follow the cycle recovery procedure specified in the manual for the E-Nr; there is no fixed time for E33 to disappear. Do not add vinegar, oil or other remedies to neutralise the foam.

See how much detergent to use when preparing the next load. If the warning reappears despite using the correct dose, or occurs alongside a drainage problem, note these conditions and request assistance. The code does not confirm that a sensor is faulty.

Keep the packaging and note the amount used if the problem began after changing detergent.

View all articles in Siemens washing machine error codes and warnings