Siemens E33 warning: excessive foam

E33 is documented by Siemens as a warning for excessive foam. Check the dose and detergent before interpreting the interruption as an internal fault.

The same amount is not right for every load

The manufacturer's documentation recommends reducing the detergent dose when the water is soft or the load is only lightly soiled. Check the detergent concentration, the actual load and any pre-treatment products. If you use automatic dosing, check its settings and avoid adding a manual dose at the same time unless the programme calls for it.

Foam can extend rinse cycles or affect the spin result. Check whether the machine is following a planned correction routine, and let it finish if there is no water leak.

After correcting the product and amount

Follow the cycle recovery instructions in the E-Nr manual; there is no fixed time for E33 to clear. Do not add vinegar, oil or other remedies to neutralise the foam.

See how much detergent to use to prepare the next load. If the warning reappears despite using the correct dose, or occurs alongside a drainage problem, record these conditions and request assistance. The code does not confirm that a sensor is faulty.

Keep the packaging and note the amount used if the issue began after changing detergent.

View all articles in Siemens washing machine error codes and warnings