E33 is documented by Siemens as a warning for excessive suds. Check the dosage and detergent before interpreting the interruption as an internal fault.
The same amount isn’t right for every load
The manufacturer’s documentation recommends using less detergent when the water is soft or the load is only lightly soiled. Check the detergent concentration, actual load size and any pre-treatment products. If you use automatic dosing, check its settings and avoid adding a manual dose at the same time unless the programme calls for it.
Suds can extend rinse cycles or affect the spin result. Check whether the machine is following an intended correction routine, and let it finish if there is no water leak.
After correcting the product and amount
Follow the cycle recovery instructions in the manual for your E-Nr; there is no set time for E33 to disappear. Don’t add vinegar, oil or other remedies to neutralize the suds.
See how much detergent to use when preparing your next load. If the warning reappears with the correct dosage or is accompanied by a drainage problem, note those conditions and request service. The code does not confirm that a sensor is faulty.
Keep the container and note the amount used if the issue began after switching detergents.
View all articles in Siemens washing machine error codes and warnings
