Err1 indicates that the door is not closed on the documented Haier washer-dryers. Note that Err: E1 without that prefix refers to drainage in the same table.
This distinction is listed in the Haier Appliances table for washer-dryers. Check the model before applying the code mapping.
Check what is preventing the door from closing
Once the machine has stopped and the door has been unlocked, move any items caught between the edge and the seal out of the way. Check whether the load is pushing the door from inside. Close it normally, without slamming it or keeping pressure on the latch.
If you see a damaged handle or latch, stop trying. Even if the door closes fully mechanically, this alone does not confirm the electrical detection needed to start the machine.
If the warning appears during a cycle with water in the machine, do not force the door open to repeat the inspection. Check the model's recovery instructions and request assistance if Err1 returns once the area is clear. Do not bypass the door switch.
Make a note of whether the machine started or whether Err1 appeared on the first attempt; include a photo that shows the prefix.
View all articles in Haier washing machine error codes and warnings
