Error E1 on AQUA washing machines: not receiving water

In the AQUA washing machine sections consulted, E1 indicates a lack of water supply. Check your model number before applying this code to an AQUA machine from another market.

This association appears in the official AQUA FAQ. Start by checking that water is reaching the washing machine.

Check the water supply and inlet

Check the washing machine’s water tap and whether there has been an interruption to the water supply. Check that the hose is not kinked. If the area has been affected by frost, consult the procedure for your model; do not force a frozen hose or apply concentrated heat.

Whether you can clean the inlet filter mesh depends on the manual. Before removing a connection that the manual permits you to remove, turn off the water and disconnect the power supply. Refit the mesh and check for leaks according to the instructions; leaving it out permanently is not a solution to low water flow.

If E1 reappears despite a correct external water supply, note whether no water enters at all or the machine fills slowly, and request assistance. The code alone does not prove that a valve or sensor is faulty.

State whether you use a mains water supply or a different installation; its conditions should be checked against what the manual permits.

View all articles in AQUA washing machine error codes and warnings