E2 indicates a drainage problem on the documented AQUA models. The correct drainage route depends on the type of machine; do not assume that the same height applies to all washing machines.
The AQUA's Japanese FAQ includes checks for the hose and drain outlet. Confirm the machine's configuration before changing the setup.
What you can check from the outside
With the washing machine stopped, check whether the hose is crushed, raised in a way the manual does not allow, or inserted so far that its end is blocked. Also check whether there is a visible blockage in the household drain.
A gravity-fed outlet and a pump-driven outlet do not necessarily use the same setup. Do not copy the arrangement used for a front-loader or tilt the machine to drain the water. Also, do not open a filter unless your model's manual describes its presence or how to access it.
Trapped water may prevent the spin cycle from starting. If an external restriction does not explain E2, request an inspection without assuming that the spin motor is at fault. E1 for water supply and U3 for spinning have their own troubleshooting guidance if either of those messages is displayed.
Make a note of where the hose ends and whether the water drained; this will help when checking the drainage route.
View all articles in AQUA washing machine error codes and warnings
