A roar that gets louder as the washer speeds up may be related to support or drive components. The sound alone does not confirm that the bearings need to be replaced.
Tell the difference between roaring and banging
Describe whether the noise is continuous and follows the speed, or consists of separate impacts. It also matters whether it started gradually, appeared after the appliance was moved, or coincides with visible play.
You don’t need to repeat a high-speed spin cycle to prove that the sound gets louder. Use observations you’ve already made, and stop using the washer if the noise comes with rubbing, movement, or the drum sitting out of position.
What a manual turn can tell you
With the washer unplugged and opened according to the usual procedure, a gentle check may reveal roughness if the design allows the drum to be turned by hand. Don’t force brakes or drive components that are designed to resist movement.
If the sound also occurs in this condition, it points towards mechanical parts, but you still need to distinguish between bearings, parts making contact, and drive mechanisms. If there is play or misalignment, describe it as a second symptom.
What an inspection needs to confirm
Bosch lists bearings and other internal components among the possible causes in its washer noise troubleshooting guide. The technician needs to identify the worn part and check the condition of the shaft, seals, and related supports. Don’t choose a repair based on “it sounds like an airplane,” since different faults can sound similar.
Don’t apply lubricant from the outside to quiet a sealed bearing. Temporarily reducing the noise wouldn’t prove that the support is still in good condition, either.
Before agreeing to a bearing replacement based only on the sound, ask them to identify the component and the related damage.
