Washer heating element: testing and replacement

The element that heats the water can fail because of an electrical break or insulation failure. A continuity test only covers part of the diagnosis and does not prove that the element is safe.

Confirm which part isn't working

Start by checking the conditions for a wash cycle that doesn't heat: the program, water supply and expected behaviour. Water level, the sensor or the electrical controls may also be involved. Not all appliances have a water heater.

A technical diagnosis distinguishes an open circuit, faulty insulation and a lack of a heating command. If an electrical protection device trips, don't keep repeating cycles to see if it happens at a particular stage.

Measurements and replacement parts

Testing requires model-specific information, suitable instruments and safe isolation. Continuity does not mean the insulation is sound between the element and the parts that must remain protected.

The replacement part must match the geometry, specifications, seal and applicable housings. The temperature sensor may need to be checked separately, even if it's near the heating element.

Installation and validation

The Electrolux procedure for its documented heating element calls for draining the appliance first and taking care with the seal. Rear access, as shown in that example, isn't universal.

Restore the position, fastening, connections and watertight seal as specified in the manual, then perform the required electrical and functional checks. Tightening a seal more doesn't guarantee a better seal. The air heater in a washer-dryer is part of a different circuit and needs its own diagnosis.

A heating-element repair must verify both heating performance and electrical safety, as well as the seal of the tub that was serviced.

View all articles in Washer Component Diagnosis and Repair