Internal drum flaps stuck in a top-load washer

In a top-load washer with a horizontal drum, open or stuck internal flaps can prevent the drum from turning. Stop using the washer, and don’t try to reposition the flaps by forcing the drum to turn.

Confirm that this is the right design

This issue affects horizontal drums with opening flaps inside an outer door. A top-load washer with a vertical agitator doesn’t use the same assembly. If only the outer door won’t open, check the door lock.

Signs that mean you should stop using the washer

A bang followed by the drum becoming immobile, an opening that is no longer aligned, or a suspicion that the flaps opened during the spin cycle all call for an inspection. Don’t try another cycle to get the drum back into position.

Safely disconnect the power. Don’t insert screwdrivers, rods or wires through the perforations: you could damage the flaps, latches, tub or heater and make the jam worse.

What the service technician should assess

They should locate the drum, check the flaps and their latches, and rule out damage to nearby surfaces. How the drum can be freed depends on the access available in that model and may require disassembly.

Tell them whether the flaps were closed before the wash, when you heard the bang, and whether you can feel resistance. You don’t need to recreate the mechanical jam to provide that information.

Freeing the drum isn’t enough if the inner latch is damaged: the flaps must also be checked to make sure they latch properly again.

View all articles in Door, lid and safety lock problems