The door or lid won’t close or lock

First, distinguish between a door that won’t fit properly and one that closes but isn’t detected by the controls. A mechanical click doesn’t confirm that the electrical safety device is working.

If it doesn’t fit properly

With the machine stopped and isolated, remove any clothing caught in the closing area. Inspect the latch, handle, hinge and housing without inserting tools. A sagging door or broken part needs to be repaired; don’t force it closed.

If the hinge or handle has visible play, don’t adjust the latch to hide it. Don’t hold a heavy lid in place with tape, either.

If it fits properly but the cycle won’t start

Check which indicator is displayed and at what stage that model locks. Some lids don’t lock immediately when the machine is turned on. Check the start command and the cycle start conditions in the manual.

If the door warning persists when the door is properly aligned, the diagnosis should distinguish between the latch, wiring, safety device and controls. An intermittent contact can’t be identified just by the sound of the mechanism.

What not to use as a test

Don’t bridge terminals, bring magnets near the sensors to fool them, or hold the latch manually during the cycle. Functional testing must be done with the appliance assembled and its safety guards restored, using the specified procedure.

Tell the service technician whether it “won’t fit” or “fits but shows the door open”; don’t replace the lock before checking the alignment.

View all articles in Door, lid and safety lock problems