A stop after starting should be interpreted according to the phase and the status of the control panel. Soak or load balancing may include pauses; a persistent stop means identifying which operation was left unfinished.
Preserve the state before acting
Note whether there is water, whether the door is still locked, whether an error appears, and what operation had started. Check whether the machine remains on or whether all indicators went out.
If there is a smell, a leak, or abnormal heating, stop using it and isolate it from a safe place. Do not complete the log through test cycles.
Phase guidance
- If it waits after trying to fill, note whether water actually entered and in what visible amount.
- If it stops before speeding up with water retained, check drainage.
- If it does not get past a documented thermal phase, the heating should be investigated without using the glass as a thermometer.
- If the lights go out or the start screen returns, continue with power-offs and resets.
Stop versus cycle still active
A machine that pumps, refills, or tries again to spin without finishing falls under phase repetition. It is not assessed the same way as one that stays silent while showing a warning.
Compare the pause with the manual and with normal behavior. There is no single minute limit that turns any wait into a fault.
If the same program stops again at the same point after you correct an identified condition, hand that pattern over to service without continuing to restart it.