Sud or Sd indicates excessive suds in compatible Whirlpool washing machines. The washer may extend the rinse cycle and limit the spin cycle while it tries to remove them.
Allow time for the suds to clear
For front-loaders, the manufacturer’s documentation describes pauses and additional rinses. If the washer is following this routine without leaking, don’t add detergent or repeatedly cancel the cycle to speed things up. The duration depends on how much needs rinsing out and on the programme.
Check the total amount of detergent
Check that the detergent is HE detergent if required by the manual. Also count any additives and products used to pre-treat clothes: the amount in the dispenser isn’t always all that ends up in the drum. A more concentrated product, softer water or a smaller load may require a smaller dose.
If you’ve changed detergents, compare the instructions on both containers; using the previous measure again may mean you use too much of the new detergent. The detergent quantity guide can help you adjust the dose for the load size and how soiled the clothes are.
Suds and restricted drainage
Check the drain hose: a kink or blockage may also contribute to the warning. If the washer stops again or retains water after you’ve corrected the product and dose, contact support. Don’t pour in oil, extra fabric softener or homemade mixtures to make the bubbles disappear.
Check how the next wash goes with the corrected dose; clearing Sud doesn’t indicate how much detergent is still in the clothes.
View all articles in Whirlpool washing machine error codes and alerts
