CE indicates overcurrent in the motor circuit of the documented LG front-load washers. Checking the wiring, insulation and electronics should be left to a service technician.
The LG table places CE in the drive circuit. The display does not identify which component caused the abnormal current, nor does it justify replacing parts by process of elimination.
When to stop trying
Stop using the washer if you smell burning, see a damaged cord, notice unusual heating or a protective device trips. Don’t run a test spin or connect the machine to an extension cord to see if the result changes.
If none of these signs are present, note whether CE appears before the first drum rotation or during the spin cycle. Check the specific reset procedure authorized by the manual for your model. If the error returns after that recovery, don’t keep trying with different loads.
An external visual check may reveal a crushed cord or improper connection, but it cannot rule out an internal insulation fault. Don’t remove panels or measure components while the washer is energized.
The inspection should investigate why overcurrent is being detected, not simply clear CE from the display.
