Err2 indicates a drainage issue on the Haier washer-dryer combos listed in the table consulted. E2, without Err, refers to a door lock issue and should be interpreted separately.
The Haier Appliances documentation points Err2 to drainage and the filter. The access procedure must match the manual for the installed model.
If water is trapped, check the drain hose first
Check whether the external hose is kinked or inserted too far into the drain. An improper connection can hinder draining; correct the setup according to the manual, without removing appliance fasteners by trial and error.
If the appliance has a user-accessible filter, stop and unplug the washer-dryer, and let the water cool. Prepare for the residual water drain as instructed before loosening the filter. Opening it suddenly when the drum is full can release a lot of water.
If the hose and the filter designated for user access are clear and Err2 reappears, arrange for the circuit to be inspected. Hearing the pump does not prove that there is sufficient flow, and the alarm alone is not enough to determine that the pump or control board is faulty.
When contacting support, specify whether the appliance did not drain at all or whether water remained after draining was partially completed.
