F8 E1, F08 E01 and Lo FL identify a water supply issue on the documented Brastemp BNF15 front-load washer. Read the full sequence and allow the automatic recovery to finish before trying to clear the warning.
The aliases appear in the BNF15ASANA manual. For the BNF15ASANA, the manual describes an eight-minute drain cycle with the door locked, which must finish before you clear the warning. Don’t mistake this for an instruction to open the door or unplug the washer immediately.
Check the water supply for this product family
The cited manual requires the specified hot and cold water connections. Check that the taps are open, the hoses aren’t kinked, and the installation matches the washer’s diagram. This requirement doesn’t apply to another Brastemp model designed differently.
Clean inlet screens or work on connections according to the user manual, with the water turned off and the power disconnected where applicable. Don’t remove safety devices to increase the flow rate.
Allow the recovery routine described for the model to finish before following the steps to clear the warning. If the warning returns, request service. The water supply requirements can help you review the installation details without attributing the code directly to the valve.
Keep F8 and E1, or Lo and FL, together when reporting the fault; the first part alone doesn’t identify this warning.
