In a hard-mounted washer extractor, rotational forces are transmitted differently than in a unit with an internal suspension system. Assessing whether the floor is suitable requires load and installation data for the specific machine.
Two paths for transmitting forces
In a hard-mounted design, the assembly is connected to the frame, transmitting forces directly to the base and its foundation. In a soft-mounted design, elastic elements and shock absorbers allow relative movement and reduce some of the force transmitted. Suspension does not eliminate mass, vibration or building requirements.
Speed Queen presents its soft-mount range as an alternative to hard mounting. This description does not mean that any soft-mounted machine can be installed on an upper floor or on a floor slab without an assessment.
Documents the professional should check
- The machine’s mass and its stated static and dynamic loads.
- The arrangement of supports, fixing method and foundation or plinth requirements.
- The condition and structure of the existing floor, and its location within the building.
- Clearances, access and the combination of other machines operating at the same time.
The Alliance F8619501EN installation manual specifies requirements for each machine and requires the support structure to be assessed, including cases that need structural advice. Its specified thicknesses and fixings apply to the models covered, not as a general industry rule.
Levelling does not certify structural strength
A machine can be level and still be supported by an inadequate floor. Adjusting the feet does not correct floor-slab deflection or a lack of specified anchoring. The explanation of domestic suspension shares some principles, but it does not replace the design of an industrial washer extractor.
Choose the location using the load and installation plan for the model; hard-mounted or soft-mounted is only the starting point.
