AEG alerts are organized by inlet, drainage, lock, protection, heating, and power. Identify the PNC to apply the table to your model.
Written code or series of flashes
In the European AEG support families, E10/E11/C1 may be accompanied by a beep or flash; E20/E21/C2, by two; E40/E41, by four. Count complete sequences and pauses, and check that your manual documents that reading. Do not turn any flashing light into a code.
The condition changes the priority
EF0/EFO and EF3 requires distinguishing between foam, laundry distribution, and a leak. If water is escaping, address the loss before any reset. EH0/EHO refers to the power supply; E60 covers heating problems without identifying a part on its own.
E50, C9, and F9: service if they persist
The official AEG help for E50 groups these messages as a motor or control fault. Consider a reset and refer it to service if the alert returns. Do not keep using the appliance with a persistent irregularity, and do not measure internal circuits to locate it.
The PNC and load type make it possible to verify the manual, filter access, and controls. This documentation does not authorize copying the meaning of an AEG code to another brand in the same group or applying it to any market.
Frequently Asked Questions
Where can I find the full model of my AEG washer?
Look for the model and PNC on the rating plate, following the location indicated in the manual. Copy the full reference and its version if shown; the commercial name does not identify all variants.
Does the same code mean the same thing in all of its washers?
You should not assume so. The PNC distinguishes platforms and variants, and the procedures for front-load, top-load, and washer-dryer models can differ even when they belong to the same family of alerts.
How do I tell a normal alert from a fault?
Compare the sequence with the manual and the cycle behavior. An active function or a wait state may be normal; a persistent supply, lock, or protection alert needs its specific troubleshooting path.
Does clearing the code confirm that the problem is solved?
No. A reset can remove the display without correcting the cause. In the case of a leak or persistent electrical fault, stop using the appliance and request help.
What information should I provide to the service technician?
Provide the model, PNC, full code or flash sequence, and load type. Indicate the cycle stage, any retained water or visible leak, and any change in installation or dosage.
Keep the full subcode; summarizing all alerts as an electrical fault removes useful diagnostic information.