Self Clean, Pure Cycle and Drum Clean refer to internal cleaning functions on different Samsung washing machines. Select the one specified in your manual and check whether it should run without a cleaning product: requirements vary between product ranges and markets.
The product name alone is not enough to apply instructions to another model
Look for Eco Drum Clean or Drum Clean+ too, if that is what appears on the control panel. In its US guide to Self Clean and Pure Cycle, Samsung says that these functions do not normally require a cleaner. The Australian guide to Drum Clean and Tub Clean prohibits adding detergents or cleaning agents to the functions it describes. An exceptional instruction for treating odours should not be applied to a programme that prohibits them.
How to use the function
- Identify the model, market and exact name of the function.
- Empty the machine and remove any visible objects. Do not leave clothes inside to make use of the cycle.
- Check what preparation is needed: any manual cleaning beforehand and any product requirements.
- Close the door or lid and select the function using the dial, button or menu described in the manual.
- Start the cycle and let it finish. Once the door unlocks and the machine has cooled, remove any visible residue as instructed, and run the rinse cycle if specified.
Reminder and residue after cleaning
The reminder prompts you to carry out maintenance as intended by the design; it does not indicate that a fault has been diagnosed. Check what the alert means and do not confuse it with a message that prevents a programme from continuing.
If residue appears during cleaning, compare how much remains after the procedure. Do not add chemicals to dissolve it without identifying what it is. If visible contamination persists, check mould and damp deposits along with the seal and the detergent drawer.
The duration, the number of cycles that triggers the reminder and the way to select the function are not the same for all Samsung machines. Refer to your manual for details when scheduling maintenance.
A function that normally runs with water alone should be used that way unless the manufacturer gives a specific, applicable instruction to do otherwise.
View all articles in Drum cleaning cycle: function, preparation and limitations
