A wash tunnel maintains continuous production by moving batches between modules. Each batch remains in the designated stages for a set time; continuous does not mean that the separation between loads disappears.
Textile flow and water flow
Prepared batches enter in a coordinated manner and pass through modules that perform functions such as pre-washing, washing and rinsing. At each transfer, the line moves the textiles to the next section. The water flow may be separate, reused or combined, depending on the design and process requirements.
Girbau documents modular batch systems that are integrated with presses and drying equipment. The existence of this downstream equipment matters: the tunnel should not be understood as a single drum that washes, extracts water and dries everything from start to finish.
Capacity and throughput
The weight of each batch and the interval between transfers determine the theoretical output. In an arithmetic example, 40 kg every 3 minutes is equivalent to 800 kg/h while that rate is maintained. This is not a stated performance figure: changes in load, start-up times, interruptions and downstream equipment can reduce actual output.
A press, extractor or dryer that receives less laundry per hour can limit the whole system, even if the tunnel is set up to move faster. With a batch extractor, coordination follows a different pattern because the same chamber completes the cycle before unloading.
Resource recovery
Reusing water or heat and adjusting the dosage are technical possibilities that must be verified against the system layout. They do not justify assuming a fixed saving or exchanging water between loads that the procedure keeps separate. Environmental assessment requires process boundaries and measured data.
To understand a line, identify where washing ends and which equipment receives each batch after transfer.
