A tunnel washer maintains continuous production by moving batches through modules. Each batch stays in the planned stages for a set time; continuous does not mean that the separation between loads disappears.
Textile flow and water flow
Prepared batches enter in a coordinated manner and pass through modules that perform functions such as prewashing, washing and rinsing. At each transfer, the line moves the textiles to the next section. Water flow may be separate, reused or combined, depending on the design and process requirements.
Girbau documents modular batch systems that are integrated with presses and drying equipment. The existence of this downstream equipment matters: the tunnel should not be interpreted as a single drum that washes, spins and dries everything from start to finish.
Capacity and throughput
The mass of each batch and the interval between transfers determine a theoretical output. In an arithmetic example, 40 kg every 3 minutes equals 800 kg/h while that rate is maintained. This is not a stated performance figure: changes in load, start-up times, interruptions and downstream equipment can reduce actual output.
A press, extractor or dryer that receives less load per hour can limit the overall system, even if the tunnel is set up to move faster. In a batch extractor, coordination follows a different pattern because the same chamber completes the cycle before unloading.
Resource recovery
Reusing water or heat and adjusting dosing are technical possibilities that must be verified in the system design. They do not justify assuming a fixed saving or exchanging water between loads that the procedure keeps separate. An environmental assessment requires process boundaries and measured data.
To understand a line, identify where washing ends and which equipment receives each batch after transfer.
View all articles in Professional and industrial washers: types and differences from domestic use
