In designs that use pressure, the water changes the pressure of the air trapped in a chamber and tube. The sensor converts this change into a signal that the control system interprets as the water level.
From water to signal
As the water rises in the area connected to the chamber, the pressure of the air connected to the sensor changes. A mechanical pressure switch can change contacts under specified conditions; an electronic sensor provides a signal that is interpreted using its calibration. These devices are not interchangeable.
The control system uses this information to limit filling and coordinate operations that depend on the water in the drum. In a design with a heater, the signal may contribute to the conditions that allow heating. The release of programme stages and protections depends on the specific logic.
Level, load and flow rate are not the same
- Level: the state of the water in the measurement system.
- Flow rate: the amount of water passing per unit of time when measured.
- Load: an estimate of the items of clothing, or the mechanical and hydraulic response of the assembly.
An absorbent load may require additional water even if the target level does not change. Cycle adaptation combines information only when the appliance has these functions.
What you cannot tell by looking at the drum
Water below the visible perforations or absorbed by the clothes may form part of the wash water. Therefore, a door glass with no visible water does not, by itself, prove that the machine has not filled.
An overflow detector, if fitted, may provide additional independent protection. Investigating inconsistent signals requires diagnosing the level system, without blowing into tubes or adjusting sensors as a universal home test.
Interpret the signal in the context of its complete circuit: chamber, tube, sensor and control system, not as an isolated reading from the door glass.
View all articles in How a washing machine works: systems and components
