Washing machine motor capacitor: diagnosis and replacement

A motor capacitor should only be investigated in designs that include one. A humming noise with failure to start can also be caused by a mechanical blockage, the power supply or the motor, so it does not justify replacing the capacitor straight away.

Do not confuse components that look similar

A start or run capacitor is part of a specific design. The mains input filter and capacitors on a circuit board or in an electronic drive serve other purposes. A dual capacitor should not be treated as a simple component with spare connections.

First identify the type of motor. On a twin-tub machine that will not spin, the fact that one section works does not establish the electrical condition of the other.

What a valid check requires

The technician must have the wiring diagram and specification, and follow a safe isolation and discharge procedure. Unplugging the machine does not prove that a capacitor has fully discharged. Do not short-circuit its terminals or improvise a discharge method.

Measurements must be interpreted against the component limits and the prescribed method. Appearance alone cannot rule out a fault, and a single reading does not resolve a possible blockage accompanied by humming.

How to choose a replacement

The capacitance, duty type, required rated voltage, connections and mounting of the compatible partmust all be respected. Do not choose an approximate capacitance or increase the value in an attempt to improve starting.

After replacement, the complete circuit should be checked for correct operation and the casing refitted before validation. Live electrical tests are not part of a general domestic check.

Note down the complete part number and its application to the model: a partial marking does not necessarily identify an equivalent capacitor.

View all articles in Washing machine component diagnosis and repair