E2 refers to a drainage failure in the documented AQUA models. The correct drainage route depends on the type of machine; do not use one height for all washing machines.
The AQUA's Japanese FAQ includes checks for the hose and drain outlet. Confirm the machine's configuration before changing the setup.
What you can check from the outside
With the washing machine switched off, check whether the hose is crushed, raised in a way that the manual does not allow, or inserted so far that its end is blocked. Also check whether there is a visible blockage in the household drain.
A gravity drain and a pump drain do not necessarily use the same setup. Do not copy the arrangement used for a front-loader or tilt the machine to drain the water. Also, do not open a filter unless its presence or access is described in the manual for your model.
Trapped water may prevent the machine from moving on to the spin cycle. If an external blockage does not explain E2, request an inspection without assuming the spin motor is at fault. E1 for water supply and U3 for spinning have their own troubleshooting guidance if those are the messages displayed.
Note where the hose ends and whether the water drained; this will help when checking the drainage route.
View all articles in AQUA washing machine error codes and alerts
