E2 error on AQUA washing machines: won’t drain

E2 refers to a drainage issue on the documented AQUA models. The correct drain outlet setup depends on the type of machine; don’t use one standard height for all washing machines.

The AQUA FAQ in Japanese includes checks for the hose and drain outlet. Confirm the machine’s design before changing the setup.

What you can check from the outside

With the washing machine stopped, check whether the hose is crushed, raised in a way the manual doesn’t allow, or inserted so far that its end is blocked. Also check for any visible blockage in the household drain.

A gravity drain and a pump drain don’t necessarily use the same setup. Don’t copy the arrangement for a front-load washer or tilt the machine to drain the water. Also, don’t open a filter unless your model’s manual describes its presence and how to access it.

Trapped water can prevent the machine from moving on to the spin cycle. If the external restriction doesn’t explain E2, request an inspection rather than attributing it to the spin motor. Refer to the separate guidance for E1 (water supply) and U3 (spin) if either of those messages is displayed.

Note where the hose ends and whether the water drained; this will help with checking the drain route.

View all articles in AQUA washing machine error codes and alerts