An agitator or pulsator that moves freely may have a damaged connection to the shaft, though some designs normally allow partial movement. Inspection requires identifying the part and how it receives motion.
What assembly is inside the tub
It may be a low-profile plate or impeller, a one-piece agitator, or an assembly with several sections. Fasteners, couplings and internal mechanisms vary between models; they do not all contain the same ratchets.
If the machine simply fills without agitating, that symptom requires a broader diagnosis. With a twin-tub washer with no wash movement, its specific controls and drive system also matter.
How to distinguish wear from a lack of drive
A technical inspection should determine whether motion reaches the shaft, whether the fastener transfers it to the assembly, and whether any section is damaged. Worn splines can affect the part's housing, the shaft, or both.
If the shaft is not receiving the intended motion, replacing the plate will not fix the problem: the drive systemshould be checked. Do not run the washing machine with safety guards or interlocks disabled to observe it.
Removal and replacement
Remove the part only by following the applicable instructions, with the power supply isolated and the assembly stopped. Do not prise off a stuck part against the tub or strike the shaft.
Replacement should restore the intended connection, fastening and movement, using the correct assembly. Being able to lift a decorative cover easily does not mean the entire agitator is designed to be removed by the user.
A new part fitted onto damaged shaft splines may still slip; check both sides of the connection before ordering a replacement.
View all articles in Diagnosing and repairing washing machine components
