E8 is an excessive water level alarm in the documented Haier washer-dryer combos. Do not start another fill to check it, or assume that a reset has fixed the problem.
The Haier Appliances table refers this issue to service. The code identifies a water level condition, not the part responsible for it.
Prioritise controlling the water
If the water level rises or a leak appears, stop using the appliance and turn off the water supply if it is safe to do so. Do not force the door open while water is retained inside. If there is moisture near the electrical supply, avoid touching plugs or the casing and get help to isolate the appliance from a dry area.
Make a note of whether water continued to enter after the programme was stopped and whether any water came out of the appliance. Do not reproduce this behaviour by opening the tap again.
An external inspection can help the service team, but it cannot distinguish between a valve, sensor and electronic fault. Do not blow into internal tubes or replace parts by trial and error. Even if the water level drops, have the appliance checked before using a machine that overfills again.
Provide the model reference and sequence of events so the technician can check both the filling and water level detection.
View all articles in Haier washing machine error codes and alerts
