E4 indicates that the Haier washer-dryer is not reaching the expected water level. The available water supply, its path and the level detection must be considered separately before diagnosing a fault.
The Haier USA washer-dryer table documents this meaning. The table places this detection after eight minutes without reaching the selected level in those washer-dryers. This time limit does not apply to the entire brand.
If it started after installation or a power cut
Check that the water supply has been restored and that the washer-dryer tap is open. Look for kinked hoses and confirm the number of inlets required by the manual, without copying connections from another market.
If the water supply seems normal but E4 reappears, do not conclude that the sensor is faulty. The fill circuit may need to be checked; visible water alone does not prove that the expected level has been reached.
Accessible mesh filters should only be cleaned as instructed in the manual, with the taps turned off and the appliance isolated from the electricity supply. Do not open valves or add water through the drawer to override the alarm.
If your display says Err5, retain that spelling and check the series; a matching symptom does not mean the codes are equivalent across all platforms.
Tell support whether little or no water enters, or whether water enters but the programme does not progress; each observation points to a different possibility.
View all articles in Haier washing machine error codes and alerts
