Error E8 in Haier washing machines: excessive water level

E8 is an excessive water-level alarm in the documented Haier washer-dryer combos. Don’t start another fill to check it, and don’t mistake a reset for a repair.

The Haier Appliances table refers this issue to service. The code identifies a water-level condition, not the part responsible.

Prioritise controlling the water

If the water level rises or a leak appears, stop using the machine and turn off the water supply if it’s safe to access. Don’t force the door open while water is trapped inside. If there’s moisture near electrical components, avoid touching plugs or the casing, and get help to isolate the appliance from a dry area.

Note whether water continued to flow after the programme stopped and whether any water escaped from the appliance. Don’t recreate this behaviour by turning the tap on again.

What you can observe from the outside may help the service technician, but it can’t distinguish between a valve, sensor and electronics fault. Don’t blow into internal tubes or replace parts by trial and error. Even if the water level drops, arrange the appropriate inspection before using a machine that overfills again.

Provide the model reference and sequence of events so the technician can check both the filling system and water-level detection.

View all articles in Haier washing machine error codes and alerts