E02 on Hoover Dynamic Next is associated with an inability to fill or an insufficient water supply. Check the tap, hose and installation according to the model.
If no water enters
The manufacturer’s documentation points to water availability and pressure. Check whether the tap is open and whether there is a household water supply interruption. Inspect the accessible part of the hose: a kink or trapped section can restrict the water inlet.
If the manual authorises cleaning the mesh filters, turn off the water and prepare to disconnect the hose before accessing them. Refit the filter and seal, then check the connections. See maintaining inlet mesh filters. Do not use a pressure reference from another appliance.
If water enters but does not stay
Note whether water is also draining away during filling, and compare the drain position with the manual. Dynamic Next support guidance includes checking the pump in certain situations; this does not mean that every E02 error requires opening the drain filter.
After correcting an accessible issue, follow the panel’s instructions to try again. If the problem persists, tell the service team the model and how the water is behaving. Do not assume E02 means the same thing on every Hoover model, or replace a valve based on the code alone.
Distinguishing between no water supply and water that enters but is then lost helps avoid checking the wrong part of the circuit.
View all articles in Hoover washing machine error codes and alerts
