Clean the two tubs separately: in the wash tub, check for residue, the pulsator and any lint filters; in the spin tub, check the accessible basket and rim. Drain and rinse only as directed in the manual for your semi-automatic washer.
Before cleaning by hand
Finish the cycle and wait until all parts have come to a complete stop. Drain the washer using the designated system, then disconnect the power before accessing the areas to be cleaned. Never put your hand in a basket that is still spinning or tamper with the lid lock.
Check whether the washer drains by gravity or by pump. This determines the approved way to drain it; do not tilt the appliance or change hoses to improvise. If the water does not drain as it should, resolve the issue before filling the washer again.
Check each tub separately
- Wash tub: remove visible solids and wipe the walls, rim and pulsator surface with a soft cloth. Do not loosen its screw or insert tools beneath the plate.
- Spin tub: check the empty basket, opening and inner lid, if there is one. Remove only parts that the manual says can be taken out; do not tuck cloths between the basket and its housing.
- Lint filters and overflow: locate the lint filter and any parts intended for maintenance. The overflow may have its own assembly; do not remove a cover just because it looks like one on another model.
Keep water away from the controls, cord, motor and cabinet. Cleaning a tub does not mean you can rinse the entire appliance with a hose.
Rinsing and drying
Follow the manual's instructions for filling, agitation or rinsing during maintenance. Not all twin-tub washers have a self-cleaning function or can be used with hot water. Use a compatible product only when specified.
After draining, check both tubs: residue may have transferred from one to the other along with the laundry. Put the lint filters and retaining parts back in place, dry the surfaces you can reach, and leave the lids in a safe position for ventilation.
If dirt remains beneath a pulsator that users cannot remove, the next step is to consult a technician about maintenance, not to try to pry it off.
