FA refers to the water-level sensor circuit in the Haier washer-dryers listed in the table. Diagnosis requires checking the system, not assuming that a pressure switch is faulty.
The Haier Appliances documentation assigns FA to level detection and recommends seeking assistance. It does not describe a household cleaning procedure that will repair this circuit.
What information helps with diagnosis
Note whether it appears when switching on, while filling or when attempting to drain. Check whether water is left inside, the water level is rising or there is an external leak. If the water continues to rise, shut off the water supply and stop using the appliance; this takes priority over clearing the alarm.
Keep a record of any previous messages too. Only refer to E4 or E8 if they actually appeared; do not use them to choose a different explanation for a persistent FA error.
Do not blow into pressure tubes, disconnect the sensor or test circuits with the appliance open. An external inspection can document the condition, but it cannot prove that the internal circuit is working properly.
Request an inspection and provide the model, code and stage at which it appeared; avoid asking for a specific part before the cause of the FA error has been checked.
View all articles in Haier washing machine error codes and warnings
