FA refers to the water-level sensor circuit in the Haier washer-dryer models listed in the table. Diagnosis requires checking the system, not assuming the pressure switch is faulty.
The Haier Appliances documentation assigns FA to level detection and recommends service. It does not describe a household cleaning procedure that will repair this circuit.
What information can help with diagnosis
Note whether it appears at startup, while the machine is filling, or when it tries to drain. Check for water left inside, a rising water level, or an external leak. If the water keeps rising, shut off the water supply and stop using the machine; this takes priority over clearing the alarm.
Also keep a record of any earlier messages. Check E4 or E8 only if they actually appeared—not as alternative explanations for a persistent FA.
Do not blow into pressure hoses, disconnect the sensor, or test circuits with the appliance open. An external inspection can document the condition, but it cannot prove that the internal circuit is working properly.
Request an inspection and provide the model, code, and stage when the error occurred; avoid requesting a specific part before the cause of FA has been checked.
