Error E12 on Midea washers: overfill detection on L11

E12 indicates overfill detection on Midea L11. If the water level is rising or water is outside the washer, stop the water supply and avoid triggering another alarm by starting a new cycle.

The L11 technical manual verifies the excessive water level condition. The code alone does not indicate whether the valve, water level reading or electronics have failed.

Document what happened without filling it again

Note whether water continued to enter after you stopped the programme and whether any water escaped from the washer. Turn off the water tap if you can do so safely. Do not turn it on again to see if the problem recurs.

If water reaches electrical connections, avoid contact and get help to disconnect the power from a dry, safe location. Do not force the door or tilt the washer to remove water from its base.

Even if the visible water level has dropped, keep the E12 code and request an inspection if it reappears. Do not enter the technical manual’s service mode or blow into pressure tubes: altering the detection system may affect the fill safeguards.

A service technician should check the cause of the overfill and how it is detected; clearing the warning does not prove that the circuit is working correctly.

View all articles in Midea washer error codes and warnings