The energy used for a wash is measured in kWh; the rated power, in W or kW, does not necessarily remain constant throughout the cycle. The variable cost is calculated by multiplying the energy used by the applicable tariff.
Use an energy figure, not the maximum power
Use the energy consumption for the specified programme or a suitable measurement of the complete cycle. If you use a meter, it must be compatible with the appliance’s connection and load; do not modify wiring to take a measurement. The figures on an energy label relate to its test conditions and do not predict the exact energy use of every load of washing.
Heating, spinning, pumping and pauses vary during the cycle. Multiplying the rated maximum power by the entire cycle duration assumes the machine runs constantly, rather than measuring its actual energy use. The calculation method from SA.GOV.AU also distinguishes between loads that do not run continuously at full power.
Calculation using assumed values
If a cycle uses 0.65 kWh and the variable tariff is 0.20 monetary units/kWh, the energy cost is 0.65 × 0.20 = 0.13 monetary units. Twenty identical cycles would use 13 kWh and cost 2.60 monetary units. These are illustrative figures, not a tariff or typical energy consumption.
For a time-of-use variable tariff, calculate each period based on the energy used during it. Do not allocate fixed charges as though they increase with every cycle. Include standby or digital connectivity when you have applicable measurements or data.
Define what is excluded
If hot water is supplied from elsewhere, account for that energy separately for a complete picture. For a washer-dryer, distinguish washing from drying. To check for a change, compare equivalent loads and results before calling it a saving.
Record the energy used, programme, load and tariff; this lets you recalculate without making further assumptions about power.
View all articles in Washing machine efficiency: electricity, water and sustainability
