On some GE top-load SmartDispense washers, H2O may appear when both the detergent and fabric softener reservoirs are detected as empty. It does not automatically mean there is no water coming from the tap.
Check the reservoir selection
The manufacturer's documentation explains that a low level with bulk dispensing selected can prevent the cycle from starting. Check the indicators for each reservoir and whether both functions are actually enabled.
On a compatible model, temporarily disabling both dispensers using the procedure in the manual can help check whether the cycle starts again. If it does, the issue points to dispensing; it is not a test of every part of the washer.
Refill without assuming a universal amount
When first used or completely empty, the reservoirs may need the initial fill specified so the system registers a level. Use the amounts and products specified for your appliance, without going above the marks or mixing detergent and fabric softener.
If you are washing in manual mode, check where and how much product to add so it is not later dispensed automatically as well. If H2O continues to appear even though the reservoirs are correctly filled, contact support and tell them which indicators you observed.
If the display says H2O Supply, return to the GE index to identify the platform and the water inlet guide; that message follows a different troubleshooting path.
Take a photo of the levels and the selected dispensing functions before changing them.
View all articles in GE Appliances washer error codes and alerts
